MCS Pachmyer Vindicator Pistol Grip

[badboybeeson]

Let's see who's paying attention today


https://ine.soundestlink.com/ce/v/63...6fa6ee75ba7aa3

MCS Pistol Grip

We have 5 fully finished and ready to ship! Production has started on these.... Looking at 2-3 weeks! This listing is for preorders and that is what you will see when ordering. First 5 preorders will be filled with the stock we have. Everything ordered after that will be a preorder. This is an Remington type S&J Hardware MCS Pachmyer Vindicator grip. Compatible with all S&J Hardware MCS components. To install this, you must have our receiver plate and nut both sold seperately. Finished in black Cerakote.

[bfiles]

Reciever plate needed to mount the grip will fit any 870 chinese/clone etc..?

[tjoke]

Order in! Thanks Simon. Can’t wait to see what else you have in pipeline

[badboybeeson]

Reciever plate needed to mount the grip will fit any 870 chinese/clone etc..?

Receiver plate needed and the short receiver nut. We also make those

[acog123]

Well those went frustratingly fast (I didn't manage to get one). :D

Well done guys, been looking forward to these.

Is there a certain number needed for the pre-order and how many do you think will be available (the price still the same)? Any plans to make the MCS Speedfeed stock as well?

[FEEDMEMORE]

Receiver plate needed and the short receiver nut. We also make those

Wait what am I missing why is this 400$? Isn't the grip still sold by lymans for 75usd?

[badboybeeson]

Well those went frustratingly fast (I didn't manage to get one). :D

Well done guys, been looking forward to these.

Is there a certain number needed for the pre-order and how many do you think will be available (the price still the same)? Any plans to make the MCS Speedfeed stock as well?

They sold out in moments.
Next full run will be 200 PC.

The speed feed stocks we have the last production for the MCS before they went bankrupt.
But only some of the parts so it's work in process

[acog123]

I see the pre-order page just went up, I'll be ordering. Again nice job guys, they look amazing. I'm sure a fair bit of reverse engineering went into it.

They'll sell well (especially in the States considering original ones go for 400-500 US if you can find them)

[dutchm0n]

Are you guys going to make the plate for the full length stock as well

[dutchm0n]

Double post